Wanted - scrap A10 cam followers

[Nicolasticity]

I need the four cam followers for a refurb exchange for a 1961 A10SR.

Parts are 67-0333 exhaust and 67-0332 inlet. 

Ideally scrap items that you have lying around ta but capable of refurbishment

thanks

[Joolstacho]

Mate... just be wary! Used ones would need to be very close to the original height. -Unworn. Grinding will make them too short, they won't work and they'll clatter badly as they bottom out. (Ask me how I know!)

[Nicolasticity]

Thanks They will be built up recoated,  ground to spec before they do any pushing!

[berger]

Any robin hood ?????????

[CheeserBeezer]

Nothing wrong with those, I'd reuse them!..................... only joking!

[limeyrob]

Bit tappety?

[berger]

rob they came out of my engine along with the snapped crank/ pocketed head valve seats and flat camshaft in 1980

[Nicolasticity]

They look tidy for a recoat etc and i could use them i think.  I trust the engine damage is no onen?😂

[limeyrob]

Berger - it speaks volumes for the toughness of an A10 that it was running up to that point and running well enough to break the crank!

[berger]

rob it went on a 200 mile round journey and just sounded a bit funny when i got home, that night i took it to bits and the big part of the crank fell out because the timing side still had the gears on. i must say the whole engine clutch included was a mess, i managed to get a whole unit that a bloke had cut out of a  bsa frame and that unit is what i rebuilt and have today, he put a water cooled suzy  engine in the bsa frame and made a kneeler.

[berger]

Nicolas EH?????