Regrind or replace?

[Daveh67]

Good evening everyone.

Cam followers, Tappets, Lifters and tickey tickedy ratly thinks

Part numbers 67-0332 and 67-0333 BSA description of TAPPET 

My question is do I regrind these or replace them with new ones.
Its so nice to beon the assembly stage!

[CheeserBeezer]

Build up with stellite and grind back.

[BSA500]

https://www.newman-cams.com/

Can reprofile cam followers

[Joolstacho]

But don't regrind them too short or you'll get a rattle you won't believe as they bottom-out.

[RichardL]

Well, no one mentioned replacing. I guess price might be the reason.   https://shop.srmclassicbikes.com/product/a10-cam-follower-set-stellite-hard-faced-set-4

Richard L.

[RichardL]

On the other hand, here are  cheaper versions from Draganfly:   https://draganfly.co.uk/shop/75097/tappet-exhaust/#67-0333   https://draganfly.co.uk/shop/75094/tappet-inlet/#67-0332

Richard L.

[limeyrob]

Those don't look bad, a very slight grind should do and the stellite is quite thick.

[bikerjohndavies]

Or you could order a new set from our own CheeserBeezer (Andrew Guttmann) https://sites.google.com/site/priorymagnetos/barrels-pistons-etc