plunger gearbox case dimension

[RDfella]

OK, here's an unusual one.
Plunger gearbox case. The face which mates against the engine has a selector camplate pivot protruding from it. Can anyone tell me whereabouts on that flange face it is? Might save me an engine strip. Roughly in the middle as I recall, but I'd like to be a tad more precise. Measurements preferably, although a photograph of the face in question would be helpful.

Thanks,

PS - how far the camplate / bolts protrude from flange face would also help.

[Greybeard]

I found these pics online. Probably not much use to you. I hope someone has a box they can measure up for you.

[morris]

May this help?
The plate protrudes 1/4” and the bolts 5/16” above the mating edge.
If anymore questions don’t hesitate

[Greybeard]

I'm not sure you should be using a Japanese ruler to measure BSA parts. 

[RDfella]

Thanks guys, and those who pm'd me - exactly what I needed.

[Swarfcut]

RD  A variation, two piece pivot mount. Boss face 11mm from mounting face, bolt heads lie lower.

 Swarfy