« previous next »
Pages: [1]   Go Down

Author Topic: Gearbox Removal  (Read 458 times)

Offline chotus52

  • Moving Up
  • **
  • Join Date: May 2017
  • Posts: 36
  • Karma: 0
Gearbox Removal
« on: 02.06. 2020 00:27 »
Hi all,
I want to remove the gearbox from my 1955 a7 Shooting Star Swinging arm model. After removing everything on the primary side, will the box slide out past its mounts? Regards
Logged
55 GF s/a

Online KiwiGF

  • Last had an A10 in 1976, in 2011 it was time for my 2nd one. It was the project from HELL (but I learned a lot....)
  • Wise & Enlightened
  • *
  • Join Date: Feb 2011
  • Posts: 1977
  • Karma: 17
Re: Gearbox Removal
« Reply #1 on: 02.06. 2020 02:28 »
Quote from: chotus52 on 02.06. 2020 00:27
Hi all,
I want to remove the gearbox from my 1955 a7 Shooting Star Swinging arm model. After removing everything on the primary side, will the box slide out past its mounts? Regards

Not an answer to your question sorry, but nearly every gearbox job can be done without removing it  *smile* so I guess I’m asking if you REALLY need to remove it, as that is a pain  *work*
Logged
New Zealand

1956 A10 Golden Flash  (1st finished project)
1949 B31 rigid “400cc”  (2nd finished project)
1968 B44 Victor Special (3rd finished project)
2001 GL1800 Goldwing, well, the wife likes it
2009 KTM 990 Adventure, cos it’s 100% nuts

beezermacc

  • Guest
Re: Gearbox Removal
« Reply #2 on: 02.06. 2020 08:19 »
You'll need to remove the plates on the right hand side.
Logged
Pages: [1]   Go Up
« previous next »