6 spring clutch hub centre removal

[scotty]

Trying to remove 6 spring clutch hub centre.

Threads are stripped on it rendering the factory removal tool useless.

Any hints or tips for removal ?

Thanks

S

[morris]

If it's the type that sits on a taper, the only thing that will work is a big enough bearing puller. You may need to loosen the primary inner case to get enough clearance.
DAMHIK

[scotty]

Thanks morris I'll give that some thought.

Haynes manual (FWIW) says in absence of the service tool one can whale on it with a hammer and brass drift to loosen the fit on the taper.

Not really seeing that one 

I'll check out pullers tomorrow

S