« previous next »
Pages: [1]   Go Down

Author Topic: Long stroke rods  (Read 1089 times)

Offline Drew Back

  • A's Good Friend
  • ***
  • Join Date: Jun 2014
  • Posts: 172
  • Karma: 0
Long stroke rods
« on: 23.03. 2015 20:07 »
Could I use a set of long stroke rods as well as crank in an early A10 motor since they had the same stroke??
Logged

Online trevinoz

  • Newcastle, N.S.W. Australia.
  • Wise & Enlightened
  • *
  • Join Date: Jul 2006
  • Posts: 3234
  • Karma: 71
Re: Long stroke rods
« Reply #1 on: 23.03. 2015 20:27 »
Long stroke = 82mm, A10 = 84mm.
Different drive side main bearing diameter.
Crappy steel rods.
Why bother?
Having said that, you then get the problem of different rod length, if any, and piston pin height.
Logged

Offline Drew Back

  • A's Good Friend
  • ***
  • Join Date: Jun 2014
  • Posts: 172
  • Karma: 0
Re: Long stroke rods
« Reply #2 on: 23.03. 2015 20:35 »
Woops my mistake I just realized the stroke was different, just trying to get parts together to build my next engine at least the crank would work..
Logged

Offline Drew Back

  • A's Good Friend
  • ***
  • Join Date: Jun 2014
  • Posts: 172
  • Karma: 0
Re: Long stroke rods
« Reply #3 on: 25.03. 2015 16:28 »
Just to be 100% the crank is totally diferent and will not work??
Logged

Offline muskrat

  • Global Moderator
  • Wise & Enlightened
  • **
  • Join Date: Jul 2009
  • Posts: 11046
  • Karma: 132
  • Lithgow NSW Oz
    • Shoalhaven Classic Motorcycle Club Inc
Re: Long stroke rods
« Reply #4 on: 25.03. 2015 19:30 »
It would take a lot of work (drive side journal and a mm off the barrels) and calculations (balance factor) to put a L/S crank in an A10 and with the shorter stroke you'd end up with an "A seven tenths". I'd rather spend the time, effort and $$ on a LJ crank & rods.
Cheers
Logged
'51 A7 plunger, '57 A7SS racer now a A10CR, '78 XT500, '83 CB1100F, 88 HD FXST, 2000 CBR929RR ex Honda Australia Superbike .
Australia
Muskys Plunger A7

Offline Drew Back

  • A's Good Friend
  • ***
  • Join Date: Jun 2014
  • Posts: 172
  • Karma: 0
Re: Long stroke rods
« Reply #5 on: 25.03. 2015 22:28 »
Ok just makeing sure since im learning about this stuff now I have to be on the hunt for an A10 crank  thank you
Logged
Pages: [1]   Go Up
« previous next »