Primary chain tensioner

[Minto]

Hi all, I'm having difficulty finding a primary drive chain tensioner screw 67 1268, my engine is missing this part and the tensioner plate was just bolted up very tight. The hole for the screw is stripped out all bar about 4 threads.
I've tried all the usual places to no avail and I've looked on the nut and bolt chart but it has no details. Does anyone know what size and thread  this part is?
I'll need to fill, drill and re-tap it (when my tap n die set arrives)and find a suitable bolt to adapt.
Sorry about the ramble, it's way past my bed time.
Thanks
Jase

[Russ]

Jase the tensioner stud, 67-1268 is 3/8 whitworth by 2-1/4 inches. The nut, 67-1266 is a 3/8 Whitworth nylock nut. From memory? I purchased these nuts from Andrew at Priory Magnetos.
3/8 Whitworth nuts from my local Bunnings have the correct thread but not the correct head size for Whitworth spanners. I had the bolt so didn't need to source one.
Russ

[Minto]

Cheers Russ
Unfortunately Priory didn't have one and as far as I can find, nor does anyone else. I've got an appropriately sized bolt I can use though. Thanks.
Jase

[muskrat]

G'day Minto.
There's one here https://mikesclassiccyclespares.com/product/67-1268/ post shouldn't be too much.
I made my own from a threaded bar.
Cheers

[Minto]

G'day Minto.
There's one here https://mikesclassiccyclespares.com/product/67-1268/ post shouldn't be too much.
I made my own from a threaded bar.
Cheers

Cheers Muskrat
Going to do the same with a bolt now I know what size it is.
Jase

[Minto]

Was going to make one and then one came up of eBay. Hoorah!